[2021] Pass Network Appliance NS0-516 Exam Updated 180 Questions
Get 2021 Updated Free Network Appliance NS0-516 Exam Questions & Answer
NetApp NS0-516 Exam Topics:
| Section | Objectives |
|---|---|
| Host Side | -Describe the different host connection options for E-Series systems. -Describe how to configure hosts for multipathing. |
| Documentation | -Describe the process of reviewing and preparing a site for implementation of E-Series. -Describe the information you give a customer after deploying a solution. |
| Management | -Describe the administrative tasks for managing E-Series systems with SANtricity System Manager. -Describe the management security features in SANtricity System Manager and SANtricity Unified Manager. -Describe when and how to configure and use SANtricity Unified Manager. |
| Storage Configuration | -Describe how to setup alerting and notification for the E-Series system. -Describe how to create and administer Volume Groups or DDP and associated volumes. -Describe physical and logical storage requirements. -Describe the setup of CHAP for an iSCSI environment. -Describe when to use DDP or Volume Groups. |
| SAN | -Describe the end-to-end network configuration for Fibre Channel and Ethernet. |
| Toolbox | -Describe the tools required to design and implement an E-Series solution. |
| Hardware | -Describe the hardware components in an E-Series storage system. -Describe Fibre Channel, Ethernet, Infiniband and SAS cabling. -Describe the appropriate tasks for adding additional storage to an E-Series system. -Describe drive encryption features. |
| Protection | -Describe how Data Assurance with media scan protects your data. - Describe SANtricity data protection features. |
| Troubleshooting | -Demonstrate the steps for troubleshooting an E-Series system. -Demonstrate how to analyze multipathing issues between a host and an E-Series system. |
NEW QUESTION 30
Which component of an E-Series storage system should always be upgraded first? (Choose the best answer.)
- A. SANtricity management client
- B. Controller firmware
- C. ESM firmware
- D. Controller NVSRAM
Answer: B
NEW QUESTION 31
The system automatically disables write caching when _________. (Choose the best answer.)
- A. the system detects a small percentage of cache hits over a 10-minute timeframe
- B. there is a failed controller on the system, so that cache mirroring is unavailable
- C. a disk pool is being expanded by adding a drive
- D. a failed disk drive has put a volume group into a degraded state
- E. more than 4 unique host identifiers are trying to access the same volume
Answer: D
NEW QUESTION 32
Exhibit:
Referring to the exhibit, which three steps would you take to solve the problem shown in the event log? (Choose three.)
- A. Reinitialize the FC switch
- B. Swap out the HBA on the FC switch
- C. Move the connection to another controller port
- D. Swap out the SFP in the controller port
- E. Swap out the FC cable
Answer: A,D,E
NEW QUESTION 33
Which two errors would fail a pre-upgrade health check? (choose two.)
- A. An excess number of event log events are present
- B. Volumes are reported on a non-preferred path
- C. Hot spares are in use
- D. I/O is being processed
Answer: A,C
NEW QUESTION 34
A d-stripe within a disk pool is always the equivalent of _______. (Choose the best answer.)
- A. 9+1 RAID 5
- B. 5+5 RAID 10
- C. 10+0 RAID 0
- D. 9+1 RAID 3
- E. 8+2 RAID 6
Answer: E
NEW QUESTION 35
How many paths provide optimal redundancy from a host through a switched topology to a storage system?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 36
Exhibit:
An administrator is asked to create a 5532 GiB volume from the volume group.
Referring to the exhibit how would the administrator complete this request?
- A. Create the volume from the available capacity
- B. Create the volume after performing space reclamation
- C. Create the volume after consolidating the capacity
- D. Create the volume after adjusting the preservation capacity
Answer: A
NEW QUESTION 37
The Netapp E-Series system with a 32 Gb FC Host Interface Card (HIC) requires which type of fiber cable to connect to switches or to connect directly to hosts extending up to 100 meters?
- A. OM4
- B. OM3
- C. OM2
- D. OM1
Answer: B
NEW QUESTION 38
What should you do to confirm a component failure prior to replacing hardware? (Choose the best answer.)
- A. Power cycle the storage array
- B. Run the Recovery Guru
- C. Run chkdsk on the client
- D. Check the Major Events Log
Answer: B
NEW QUESTION 39
Review the diagram.
Is this cabling correct or incorrect, and why? (Choose the best answer.)
- A. The cabling is incorrect because they have been daisy-chained.
- B. The cabling is correct because it follows the recommended E-Series cabling method.
- C. The cabling is incorrect because the controllers are cabled from the host port.
- D. The cabling is incorrect because it usesthe top-down bottom-up cabling method.
Answer: A
NEW QUESTION 40
Barring a specific instruction from technical support or in the release notes, what software should be upgraded or installed first?
- A. Controller firmware
- B. ESM firmware
- C. Disk firmware
- D. SANtricity client
Answer: D
NEW QUESTION 41
Which three are techniques for troubleshooting the management connection? (Choose three.)
- A. Ping the controller ports (out-of-band).
- B. Delete the EMWdata_vxx.bin file (in- and out-of-band).
- C. Restart the agent (in-band).
- D. Check the Ethernet cables (out-of-band).
Answer: A,C,D
NEW QUESTION 42
If you have to replace the battery on a controller, you should put the controller into which state?
- A. suspend
- B. service mode
- C. lockdown
- D. quiesced
Answer: B
NEW QUESTION 43
When replacing failed disks, what is a consideration for replacement disks?
- A. The replacement disk must match the security capabilities of the existing driver.
- B. The replacement disk must be of greater capacity to rebuild the data structure from the failed disk.
- C. The replacement disk must have DAC store already installed on it.
- D. The replacement disk can be of any technology; for example, an HDD can replace an SSD.
Answer: A
NEW QUESTION 44
What does the CHAP secret accomplish for an E-Series system?
- A. SAS authentication
- B. Ethernet management authentication
- C. iSCSI authentication
- D. FC authentication
Answer: C
NEW QUESTION 45
What SANtricity package(s) must be installed on a Windows server when it is acting as both a data host and a storage management host?
- A. The client and agent
- B. The client, agent, and utilities
- C. The client, failover driver, and agent
- D. The client
Answer: C
NEW QUESTION 46
Which file contains the configuration for a multipath driver for FC on Linux systems?
- A. /etc/dm-multipath.conf
- B. /etc/kernel/mp.conf
- C. /etc/multipath.conf
- D. /opt/multipath/multipath.cnf
Answer: C
NEW QUESTION 47
How many partitions are being used in this storage system?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 48
When you replace a component, why should you wait for the action to register in the storage manager?
- A. To ensure that the storage manager completes the component repair sleep cycle
- B. To ensure that the administrator has time to complete ESD procedures
- C. To ensure that the host OS completes SOD processing
- D. To ensure that the controller configuration database has a record of the change
Answer: D
NEW QUESTION 49
......
NetApp NS0-516 Exam Certification Details:
| Number of Questions | 60 |
| Recommended Training | E-Series Fundamentals (WBT) Configuring and Monitoring NetApp E-Series and EF-Series Storage Systems (ILT) |
| Exam Price | $150 USD |
| Exam Name | Implementation Engineer SAN Specialist E-Series |
| Exam Code | NS0-516 NCIE SAN Specialist E-Series |
| Exam Registration | PEARSON VUE |
| Sample Questions | NetApp NS0-516 Sample Questions |
| Passing Score | 75% |
| Duration | 90 minutes |
Verified NS0-516 exam dumps Q&As with Correct 180 Questions and Answers: https://www.vceprep.com/NS0-516-latest-vce-prep.html
NS0-516 Dumps PDF and Test Engine Exam Questions: https://drive.google.com/open?id=1DQyp83xw2P9xA8uK7ncCnk7H8dMvJd6B