Get Instant Access of 100% REAL H12-323_V2.0 DUMP Pass Your Exam Easily
H12-323_V2.0 Free Exam Questions with Quality Guaranteed
Passing the Huawei H12-323_V2.0 (HCIP-WLAN V2.0) Certification Exam is an important achievement for IT professionals who wish to expand their knowledge and skills in WLAN network technology. HCIP-WLAN V2.0 certification is widely recognized by industry leaders and can open up new career opportunities for individuals who hold it. In addition, the Huawei HCIP-WLAN V2.0 certification path provides a solid foundation for further study in advanced WLAN network technologies.
NEW QUESTION # 101
While designing signal coverage for a WLAN network planning project, which of the following issues should be considered and confirmed? (Multiple choice)
- A. Signal attenuation due to obstacles
- B. AP Antenna Selection
- C. AP deployment locations
- D. Single-user bandwidth requirements
Answer: A,B,C
NEW QUESTION # 102
In NaviAC networking, the data forwarding mode in the vapprofile policy must be configured as tunnel forwarding, otherwise NaviAC cannot receive service data
- A. False
- B. True
Answer: B
NEW QUESTION # 103
Which of the following WAC high-reliability networking methods can support WAC remote deployment? (Multiple choice)
- A. VRRP hot backup
- B. N+1 backup
- C. Dual-link hot backup
- D. Dual-link cold backup
Answer: B,C,D
NEW QUESTION # 104
Huawei's wireless load balancing function can balance the load of APs in the WLAN network and fully guarantee the bandwidth of each terminal. APs with load balancing function can be connected to different wireless controllers.
- A. False
- B. True
Answer: B
NEW QUESTION # 105
When using CloudCampus APP for project delivery, which of the following tools does not include the one that users need to log in to the WLAM Planner project with their account?
- A. Delivery
- B. Acceptance
- C. Site Survey
- D. AP Calculator
Answer: D
NEW QUESTION # 106
An engineer configures the smart roaming policy as follows. Which of the following configuration descriptions is wrong?
- A. The high difference threshold for triggering STA roaming guidance is 16dB, and the low difference threshold is 8dB
- B. Smart roaming is triggered by detecting the terminal SNR and the terminal rate.
- C. If the terminal signal-to-noise ratio is higher than 25B, then the smart roaming conditions are met.
- D. If the terminal rate is less than 30% of the maximum rate, the smart roaming conditions are met.
Answer: D
NEW QUESTION # 107
In coverage optimization, if the AP uses an external antenna, in addition to adjusting the AP location, you can also adjust the antenna direction to meet the coverage requirements. Which of the following options are correct regarding antenna direction selection? (Multiple choice)
- A. When installing directional antennas, the distance between the 2.4G antenna and the 5G antenna should be controlled to be more than 0.5 meters
- B. Directional antennas are generally recommended to be mounted on poles
- C. Outdoor omnidirectional antennas need to be installed vertically
- D. Avoid trees, houses, etc. from blocking the antenna coverage area.
Answer: A,B,C,D
NEW QUESTION # 108
In a WLAN network, the signal strength of the wireless signal will gradually weaken during the transmission process.
Which of the following factors affect signal attenuation? (Multiple choice)
- A. Frequency
- B. Transmission distance
- C. Obstacles
- D. Power
Answer: A,B,C
NEW QUESTION # 109
In a WLAN network, what are the following advantages of using a PoE switch for power supply compared to using a PoE power adapter for power supply? (Multiple choice)
- A. Reuse network cable power supply to reduce construction costs
- B. PoE port can be remotely managed
- C. APOE switch equipment costs less
- D. No external power supply, more beautiful when deployed
Answer: A,B,D
NEW QUESTION # 110
WLAN Planner supports batch import of multiple drawings when creating a project, but there are restrictions on the drawing types. Which of the following drawing types does not support the batch import function?
- A. JPG
- B. OPNGA
- C. CAD
- D. PDF
Answer: D
NEW QUESTION # 111
Engineers are deploying Huawei's cloud management solution at the customer site. All APs in the existing network are managed by the cloud platform.
During the project implementation, the engineer logged in to the cloud AP and queried the online status through the following command line. The following is the response.
Which of the following descriptions of the command line output is wrong?
- A. The port number of the cloud platform is 10020
- B. The cloud AP has been successfully launched on the cloud platform
- C. The IP address of the cloud platform is 10.1.1.1
- D. Cloud AP obtains the cloud platform address through DHCP parameters
Answer: D
NEW QUESTION # 112
A Huawei Wi-Fi 6 AP supports up to 8x8 MIMO on the 5 GHz frequency band when working in dual-radio mode. When the 5 GHz radio works at 160 MHz frequency bandwidth, a Wi-Fi 6 STA working in 2x2 MIMO + 160 MHz mode accesses the radio. What is the maximum theoretical rate of this STA?
- A. 1.2 Gbps
- B. 9.6 Gbps
- C. 2.4 Gbps
- D. 4.8 Gbps
Answer: C
Explanation:
A Wi-Fi 6 STA using 2x2 MIMO with 160 MHz bandwidth has a maximum theoretical rate of about
2.4 Gbps. The higher values apply to more spatial streams, not to a 2x2 STA.
NEW QUESTION # 113
When designing the WLAN network planning for the lecture hall scenario, the engineer proposed two network planning solutions as shown in the figure.
Which of the following descriptions of the two solutions are correct? (Multiple choice)
- A. If the reported floor height is greater than 6 meters, it is recommended to adopt solution B, using indoor and outdoor antenna AP wall mounting
- B. It is recommended to adopt solution A. If the indoor floor height is greater than 6 meters, the external antenna AP should be installed on the ceiling.
- C. If the lecture hall is less than 6 meters high, it is recommended to use solution B, using an indoor built-in omnidirectional antenna AP ceiling installation
- D. If the lecture hall is less than 6 meters high, it is recommended to use solution A, using an indoor built- in omnidirectional antenna AP ceiling installation
Answer: A,B,D
NEW QUESTION # 114
Which of the following descriptions about AP antenna installation methods is wrong?
- A. The main lobe direction of the directional antenna should be facing the target area
- B. The closer the distance between the 4G antenna and the 5G antenna, the better
- C. The omnidirectional outdoor antenna cannot be placed randomly, but must be installed vertically to ensure that the beam direction evenly covers the designated area.
- D. The antenna installation location should avoid being blocked by building beams and metal to reduce attenuation losses caused by obstacles.
Answer: B
NEW QUESTION # 115
In WLAN networks, antenna gain is one of the most important parameters for selecting antennas.
Which of the following descriptions of antenna gain are correct? (Multiple choice)
- A. Antenna gain is a passive phenomenon; the antenna does not increase power.
- B. Antenna gain is used to measure the ability of an antenna to send and receive signals in a specific direction.
- C. The higher the gain, the farther the radio wave propagates. In actual implementation, high gain is preferred.
- D. The parameters that represent antenna gain are dBa and dBi
Answer: A,B,D
NEW QUESTION # 116
Which of the following tools can be synchronized with WLAN Planner to view network planning results on a mobile phone?
- A. Antenna Alignment
- B. eDeskA
- C. WLAN Tester 2.0
- D. CloudCampus APP
Answer: D
NEW QUESTION # 117
As shown in the figure, a company's WLAN network uses N+1 backup networking. Which of the following descriptions about N+1 backup is wrong?
- A. The backup WAC3 and the primary WAC1 and WAC2 can be deployed in different locations to ensure intercommunication between the three-layer networks.
- B. You can configure the AP's individual priority on the primary and backup WACs. The larger the priority value, the higher the priority.
- C. You can configure the corresponding MAC whitelist on the primary WAC to ensure that the AP can go online on the corresponding WAC to assist the AP in selecting the correct primary WAC.
- D. All APs under the main WAC1 and main WAC2 must be configured on the backup WAC3 to ensure that the APs can obtain the correct configuration after the WAC is switched.
Answer: B
NEW QUESTION # 118
......
Huawei H12-323_V2.0 certification exam covers a wide range of topics, including WLAN planning and design, WLAN deployment and management, WLAN security, and WLAN troubleshooting. H12-323_V2.0 exam is divided into multiple sections that test the candidate's knowledge and skills in each of these areas. To pass the exam, candidates must demonstrate their proficiency in each of these areas, as well as their ability to apply their knowledge to real-world scenarios.
H12-323_V2.0 Free Exam Files Downloaded Instantly: https://www.vceprep.com/H12-323_V2.0-latest-vce-prep.html
Practice Exams and Training Solutions for Certifications: https://drive.google.com/open?id=1wN2c5b0CItB_SN4Td74TUT66p2zB9B7n