Real 300-430 dumps - Real Cisco dumps PDF in here [Feb-2022]
Realistic VCEPrep 300-430 Dumps PDF - 100% Passing Guarantee
Topics of Cisco 300-430 Exam
The Cisco 300-430 exam evaluates the competence of the candidates in implementing the wireless network. The subject areas that are measured in the delivery of this test include QoS, FlexConnect, Multicast, monitoring, advanced location services, as well as device hardening & client connectivity security. The details of these topics are enumerated below:
FlexConnect
This domain makes up about 15% of the exam content and measures the proficiency of the students in specific areas. They will be required to demonstrate their skills in the following tasks:
- Deploying the capabilities of FlexConnect, such as FlexConnect groups & roaming, Smart AP image upgrade, split-tunnel and fault tolerance, and Flex ACL & VLAN-based central switching;
- Implementing Office Extend.
- Deploying the components of FlexConnect, including switching & operating modes;
NEW QUESTION 23
What is the difference between PIM sparse mode and PIM dense mode?
- A. Sparse mode supports multiswitch networks. Dense mode supports only one switch.
- B. Sparse mode supports only one switch. Dense mode supports multiswitch networks.
- C. Sparse mode floods. Dense mode uses distribution trees.
- D. Sparse mode uses distribution trees. Dense mode floods.
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_pim/configuration/xe-16/imc-pim-xe-16-book/imc-te
NEW QUESTION 24
You are designing a WLAN for 50 branch offices that require central management. Which controller architecture do you use?
- A. FlexConnect controllers
- B. anchor controllers
- C. per-branch local controllers
- D. autonomous access points
Answer: A
NEW QUESTION 25
Which configured is applied to prevent the network from a Layer 2 flooding of multicast frames with a seamless transfer of multicast data to the client when roaming from one controller to another?
- A. Enable multicast mode on the WLC
- B. Enable IGMP snooping on the WLC
- C. Enable IGMPv3 on the central Layer 3 switch.
- D. Create multicast groups on the central Layer 3 switch.
Answer: B
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONS
NEW QUESTION 26
Refer to the exhibit.
An engineer deployed a Cisco WLC using local EAP. Users who are configured for EAP-PEAP cannot connect to the network. Based on the local EAP debug controller provided, why is the client unable to connect?
- A. The client is falling to accept certificate.
- B. The user is using invalid credentials.
- C. The Cisco WLC local EAP profile is misconfigured
- D. The Cisco WLC is configured for the incorrect date.
Answer: B
NEW QUESTION 27
What is the default IEEE 802.1x AP authentication configuration on a Cisco Catalyst 9800 Series Wireless Controller?
- A. EAP-TLS with 802.1x port authentication
- B. EAP-FAST with CAPWAP DTLS + port authentication
- C. EAP-FAST with CAPWAP DTLS
- D. EAP-PEAP with 802.1x port authentication
Answer: B
NEW QUESTION 28
Refer to the exhibit.
An engineer is creating an ACL to restrict some traffic to the WLC CPU. Which selection must be made from the direction drop-down list?
- A. To have the complete list of options, the CPU ACL must be created only by the CLI.
- B. Packet direction has no significance; it is always Any.
- C. It must be Inbound because traffic goes to the WLC.
- D. It must be Outbound because it is traffic that is generated from the WLC.
Answer: C
NEW QUESTION 29
An engineer set up identity-based networking with ISE and configured AAA override on the WLAN. Which two attributes must be used to change the client behavior from the default settings? (Choose two.)
- A. multicast address
- B. DSCP value
- C. DNS server
- D. IPv6 ACL
- E. DHCP timeout
Answer: B,D
NEW QUESTION 30
Refer to the exhibit.
An engineer needs to configure location services in an office. The requirement is to use FastLocate and achieve higher locations refresh rates. Which location-based technique should be implemented?
- A. angulation
- B. probe-based
- C. location patterning
- D. data packet-based
Answer: D
Explanation:
NEW QUESTION 31
Which two statements about the requirements for a Cisco Hyperlocation deployment are true? (Choose two.)
- A. NTP can be configured, but that is not recommended.
- B. After enabling Cisco Hyperlocation on Cisco CMX, the APs and the wireless LAN controller must be restarted.
- C. The Cisco Hyperlocation feature must be enabled only on the wireless LAN controller.
- D. If the Cisco CMX server is a VM, a high-end VM is needed for Cisco Hyperlocation deployments.
- E. The Cisco Hyperlocation feature must be enabled on the wireless LAN controller and Cisco CMX.
Answer: D,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/wireless/mobility-services-engine/datasheet-c78-734648.html
NEW QUESTION 32
An IT administrator is managing a wireless network in which most devices are Apple iOS. A QoS issue must be addressed on the WLANs. Which configuration must be performed?
- A. Create a new AVC Profile named AUTOQOS-AVC-PROFILE and apply to all WLANs.
- B. Enable Fastlane under each WLAN setting.
- C. Enable Fastlane globally under Wireless > Access Points > Global Configuration.
- D. Enable WMM TSPEC/TCLAS negotiation under Wireless > Advanced.
Answer: B
Explanation:
Explanation
https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/technotes/86/Enterprise_Best_Practices_for
NEW QUESTION 33
Which QoS level is recommended for guest services?
- A. silver
- B. bronze
- C. platinum
- D. gold
Answer: B
Explanation:
NEW QUESTION 34
An engineer must implement intrusion protection the WLAN. The AP coverage is adequate and on-channel attacks are the primary concern. The building is historic, which makes adding APs difficult. Which Ap mode and submode must be implemented?
- A. Ap mode: monitor, Ap submode: WIPS
- B. Ap mode: local, Ap submode: WIPS
- C. Ap mode: monitor, Ap submode: none
- D. Ap mode: local, Ap submode: none
Answer: B
Explanation:
NEW QUESTION 35
Which two statements about the requirements for a Cisco Hyperlocation deployment are true? (Choose two.)
- A. NTP can be configured, but that is not recommended.
- B. After enabling Cisco Hyperlocation on Cisco CMX, the APs and the wireless LAN controller must be restarted.
- C. The Cisco Hyperlocation feature must be enabled only on the wireless LAN controller.
- D. If the Cisco CMX server is a VM, a high-end VM is needed for Cisco Hyperlocation deployments.
- E. The Cisco Hyperlocation feature must be enabled on the wireless LAN controller and Cisco CMX.
Answer: D,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/wireless/mobility-services-engine/datasheet-c78-734648.html
NEW QUESTION 36
An engineer is tuning RRM parameters to improve client connectivity. Which channel band results in the best
802.11n client compatibility?
- A. UNII-2
- B. UNII
- C. UNII-3
- D. UNII-2e
- E. UNII-1
Answer: E
Explanation:
802.11n operates on the same channel as 802.11a. For better compatibility with 802.11n clients, it is recommended to stay on lower channels (UNII-1 band).
Reference: http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/108184- config-802-11n-wlc.html
NEW QUESTION 37
Which two configurations are applied on the WLC to enable multicast, check multicast stream subscriptions, and stream content only to subscribed clients? (Choose two)
- A. Set the AP multicast to 238.255.255.255
- B. Enable 802.3x flow control mode.
- C. Enable IGMP snooping
- D. Set the IGMP timeout to 180 seconds
- E. Enable broadcast forwarding
Answer: C,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81671-multicast-wlc-lap.html
NEW QUESTION 38
An engineer is following the proper upgrade path to upgrade a Cisco AireOS WLC from version 7.3 to 8.9.
Which two ACLs for Cisco CWA must be configured when upgrading from the specified codes? (Choose two.)
- A. Permit 0.0.0.0 0.0.0.0 UDP any any
- B. Permit 0.0.0.0 0.0.0.0 UDP DNS any
- C. Permit any any any
- D. Permit 0.0.0.0 0.0.0.0 any DNS any
- E. Permit 0.0.0.0 0.0.0.0 UDP any DNS
Answer: B,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/115732-central-web-auth-00.html
NEW QUESTION 39
Which two statements about the requirements for a Cisco Hyperlocation deployment are true? (Choose two.)
- A. NTP can be configured, but that is not recommended.
- B. After enabling Cisco Hyperlocation on Cisco CMX, the APs and the wireless LAN controller must be restarted.
- C. The Cisco Hyperlocation feature must be enabled only on the wireless LAN controller.
- D. If the Cisco CMX server is a VM, a high-end VM is needed for Cisco Hyperlocation deployments.
- E. The Cisco Hyperlocation feature must be enabled on the wireless LAN controller and Cisco CMX.
Answer: D,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/wireless/mobility-services-engine/datasheet-c78-734648.html
NEW QUESTION 40
A network engineer has been hired to perform a new MSE implementation on an existing network. The MSE must be installed in a different network than the Cisco WLC. Which configuration allows the devices to communicate over NMSP?
- A. Allow TCP/16113 port on the firewall.
- B. Allow UDP/16113portonthe central switch.
- C. Allow UDP/16666 port on the VPN router.
- D. Allow TCP/16666 port on the router.
Answer: A
Explanation:
https://www.cisco.com/en/US/docs/wireless/mse/3350/6.0/CAS/configuration/guide/msecg_ch4_CAS.html
NEW QUESTION 41
......
Verified 300-430 dumps Q&As Latest 300-430 Download: https://www.vceprep.com/300-430-latest-vce-prep.html
Free Cisco 300-430 Exam Questions & Answer: https://drive.google.com/open?id=1X57cKHbluo6aYmV_UTaBWyL4lm2dD9Gt